WhatsApp)
investigate the influence replacement of natural sand by stone dust (5%, 10%, 15%, 20%, 25% and 30%) in workability, air content, compressive strength, impact strength, permeability and retraction of concrete samples. It was found that the 10% of replacement increased the compressive strength of concrete; however, 5% of stone dust was
Stone dust is a waste material obtained from crusher plants. It has potential to be used as partial replacement of natural river sand in concrete. Use of stone dust in concrete not only improve the...
crusher dust in concrete only. Investigations on full replacement of sand for mortar in brick masonry with 59 crusher dust as is available from the crusher are reported in this paper. Also, the fines below 150 micron size are removed from this unrefined crusher dust and the micro fines removed crusher dust is used for full replacement of
under taken to produce low cost concrete by blending in various ratios of hypo sludge with cement. the concrete composition can also be suitable for partial replacement (up to 60%). the fly ash, quarry rock dust can be used form 20% replacement of cement and fine aggregate in concrete.
replacement of quarried stone aggregates with destruction recycled aggregates determined that it will not have significant harmful effect on the compressive strength. Concrete containing quarry dust as fine aggregate can be effectively utilized in the construction industry with
fine aggregate or even cement. Rock dusts, often referred to as stone powders, are used in concrete and cement mortar primarily as inert additives fillers. Their positive effect on some properties of cement mortar and concrete is mainly related to the filler
Key words: Stone powder, concrete, mortar, concrete, compressive strength. INTRODUCTION Plain concrete is made by mixing cement, study is to evaluate relative performance of the concrete made by normal sand and stone dust where the coarse aggregate is crushed stone, in the same way the test is performed using Brick khoa as a coarse aggregate.
The lack of sand directly affects the construction work. Many researchers are finding different materials to replace sand and one of the major materials is quarry stone dust. By the using of quarry stone dust make a proper mix of concrete with a satisfactory strength.
replacement level of stone dust casted on 1 % dose of super plasticizer with slump vale of 25 which can be maintained by extra dose of 35 mm. Finally it can be stated that the stone dust is to be used in concrete with partially or fully replacement of fine aggregate. TABLE 4. Compressive Strength of Concrete Concrete Cube Group
5. Use of quarry dust in concrete help in workability of concrete. 6. Quarry dust is a waste product from stone crushing industry and available almost freeofcost, as partial replacement for river sand. REFERENCES [1] Study of Properties of S using Quarry ust and Fly Ash, Rama Raju,, Shankar
keeping these points in mind the replacement of marble dust by cement as pozzolanic material had been done. This project describes the feasibility of using the marble dust in concrete and mortar as partial replacement of is a building material which use especially in
#0183;#32;Compressive strength of concrete cubes prepared with successive percentage replacement of NS to CSD shows that it increases with the increase in replacement and also its values are higher in almost in all cases than cubes prepared with natural sand only. #239;#183; Ultrasonic pulse velocity test results for the M20 and M30 both concrete mix, which was prepared using crushed stone dust
#0183;#32;The influence of the stone dust content in sand on mortar properties are presented in this paper. Three stone dusts (quartz, granite and limestone) were incorporated in percentages ranging from 0 to 20% as replacement for equal weights of sand.
Stone crusher dust as a fine aggregate in Concrete for paving blocks. 3 Assistant Professor, Department of Civil Engineering, KIIT University, The test results shows that the replacement fine aggregate by crusher dust up to 50% #187;More detailed
Determination of mortar strength using stone dust as a partially replaced material for cement and sand mortar;cement;sand;compressive strength;tensile strength;stone dust;replacement; Mortar is a masonry product which is matrix of concrete. It consists of binder and fine aggregate and moreover, it is an essential associate in any reinforced structural construction.
Stone dust passing by No. 200 sieve, is used as cement replacing material and retained by No. 100 sieve is used for sand replacement. Sand was replaced by stone dust of 15%, 20%, 25%, 30%, 35%,...
INVESTIGATIONS WERE UNDER TAKEN TO PRODUCE LOW COST CONCRETE BY BLENDING IN VARIOUS RATIOS OF HYPO SLUDGE WITH CEMENT. THE CONCRETE COMPOSITION CAN ALSO BE SUITABLE FOR PARTIAL REPLACEMENT (UP TO 60%). THE FLY ASH,QUARRY ROCK DUST CAN BE USED FORM 20%REPLACEMENT OF CEMENT AND FINE AGGREGATE IN CONCRETE.
ppt on replacement of stone dust in concrete and mortar. Review on Use of Stone Dust as a Partial Replacement of...replacement for FA in concrete with w/c = and 5% limestone dust in concrete with w/c = not significantly affect the properties of fresh and hardened concrete. However, there is considerable loss in slump, irrespective of w/c ratios, if lime stone dust is in excess of 10%.
WhatsApp)